F pump

F-type centrifugal pumps are used to transport corrosive liquids that do not contain solid particles. The temperature of the medium to be conveyed is -20°C~1 60°C, and the inlet pressure of the pump cannot be greater than 6 MPa. The flow range of this series of pumps is 2m3/h to 400m3/h. The lift range is 15m to 105m. The lower limit of the lift can be up to 3m after deceleration.

Key words:

Category:

Product consultation:

Product consultation:

F-type centrifugal pumps are used to transport corrosive liquids that do not contain solid particles. The temperature of the medium to be conveyed is -20°C~1 60°C, and the inlet pressure of the pump cannot be greater than 6 MPa. The flow range of this series of pumps is 2m3/h to 400m3/h. The lift range is 15m to 105m. The lower limit of the lift can be up to 3m after deceleration.

The F-type pump is a single-stage single-suction cantilever centrifugal pump, and its main components are: pump body, pump cover, impeller, shaft, bracket, coupling, etc. There are two types of structure: front door and rear door; that is, the pump body does not move, and the impeller can be taken out from the direction of the suction port, which is called the front door; otherwise, it is called the rear door.

The bearings are rolling bearings, lubricated with grease.

According to the user's requirements, the shaft seal cavity can be equipped with a single-end mechanical seal or a double-end mechanical seal.

Related Products

OH1 ZTS


ZTS petrochemical process pump isdesigned according to API610 7thedition and VDMA24297 (light/medium)standard.

OH1 ZTB


ZTB series standardized I pumps are horizontal, single-stage, single-suction centrifugal pumps, the size and performance conform to DIN24256/ISO2858 standards.

OH3 ZTDS


The ZTDS pump needs to use a vertical drive, and the thrust load of the pump and the weight of the rotor will be supported by the thrust bearing of the pump.

OH1 PLA


The pump is a single-stage, horizontal, radial partial flow pump (also called a tangential pump), which is a special centrifugal pump. Adopt bracket structure, single suction fully open impeller, axial suction and tangential discharge. Packing seal, single-end mechanical seal or double-end mechanical seal are used according to the conditions of use, and are equipped with cooling, flushing or sealing liquid systems, and the rated pressure levels of the suction and discharge flanges are the same. Viewed from the motor end, the pump turns counterclockwise.

OH2 ZTH


This pump is suitable for conveying clean or particle-containing liquids, low-temperature or high-temperature liquids, neutral or corrosive liquids.

Advisory Message

Our staff will contact you within 24 hours (working days). If you need other services, please call the service hotline:+86-411-86800129