BB1 double suction pump

SM series pumps are single-stage, double-suction centrifugal pumps. The installation form of the pump is horizontal.

Key words:

Product consultation:

Product consultation:

SM series pumps are single-stage, double-suction centrifugal pumps. The installation form of the pump is horizontal.
Scope of application
SM series pumps are suitable for conveying liquids with traces of solid particles.
■Water supply and water treatment
■Water conservancy irrigation and sewage treatment
■Power station, thermal power plant and pipe network heating device
■Paper industry
■Marine pumps and cooling water pumps
■Salt from seawater
■Line pressurization
■Industrial process
■Offshore industry
SM series pumps can also be used as energy recovery turbines.
Performance parameters
Diameter DN125~ 800mm
Flow rate Q can reach 10000m/h
Head H up to 180m
Working pressure P0.4 ~ 6.4MPa
Operating temperature t-20~ +160°C
Design Features
The pump body is an axially split structure, and the suction and discharge pipes are located in the lower half of the pump body. The entire pump rotor can be removed for maintenance without dismantling the piping and piping valves.
The lubrication form of the bearing is thin oil lubrication, and the non-drive end bearing can also bear the residual axial force.
Shaft seals can be packing or mechanical seals. The shaft from the overcurrent part to the impeller hub is protected by a bushing, the shaft is allowed to reverse, and the pump can be driven from both ends. Usually flanges implement GB or DIN standards.
Material.
■Cast iron
■Cast steel
■Stainless steel
■Other special materials can be used upon request

 

Related Products

OH3 ZTDS


The ZTDS pump needs to use a vertical drive, and the thrust load of the pump and the weight of the rotor will be supported by the thrust bearing of the pump.

OH1 PLA


The pump is a single-stage, horizontal, radial partial flow pump (also called a tangential pump), which is a special centrifugal pump. Adopt bracket structure, single suction fully open impeller, axial suction and tangential discharge. Packing seal, single-end mechanical seal or double-end mechanical seal are used according to the conditions of use, and are equipped with cooling, flushing or sealing liquid systems, and the rated pressure levels of the suction and discharge flanges are the same. Viewed from the motor end, the pump turns counterclockwise.

OH2 ZTH


This pump is suitable for conveying clean or particle-containing liquids, low-temperature or high-temperature liquids, neutral or corrosive liquids.

Advisory Message

Our staff will contact you within 24 hours (working days). If you need other services, please call the service hotline:+86-411-86800129